Roots blower in the use of the phenomenon of oil leakage should be how to solve it?
Roots Blower在使用的過程中出現了漏油現象應該如何解決呢？下面羅茨鼓風機小編帶您了解一下。
一、葉輪之間的摩擦它的原因：葉輪上有雜質，所以造成了葉輪之間間隙過小；軸承磨損導致游隙之間增大。
Solution: Get rid of the dirt and inspect the inner parts for other damages; adjust the gap between the gears.
Second, the Roots blower it is too high temperature
Causes: too much oil in the oil tank of the Roots blower, clogging of its filter; excessive wear and tear of the impeller; poor ventilation and high temperature in the room, resulting in a high temperature of the inlet;
Solution: Reduce the oil level or hold the oil hostage; remove the blockage; reduce the differential pressure through the Roots blower; repair the gap; open vents to reduce the room temperature; increase the speed to prevent the belt from slipping.
Third, the Roots blower flow is insufficient
Its cause: clogging of the inlet filter of the Roots Blower;.
Solutions: Remove dust and blockages from the filter; tighten the belt and increase the number of roots; adjust the inlet pressure to the specified value; check and repair the pipeline.
四、羅茨鼓風機的油泄漏到機殼中它的原因：羅茨鼓風機的油箱位太高，由它的排油口漏出；其密封遭到損壞，造成軸部端漏油；壓力高于規定的值。
Solution: Lower the oil level; replace the seal; unclog its vents.
五、羅茨鼓風機的電機過載
它的原因：與規定的壓力比較，壓差過大。
解決辦法：放低壓力到它的規定數值；將多余的氣體放到大氣中或降低羅茨鼓風機的運轉速度；清除礙物；將油位調到正位。
